- 6 -
754988-100 Rev. D (5/18)
1
2
3
4
• Place the tub on a finished, level floor in the
desired location.
ª Using an erasable pencil or marker, trace the outline of
the base of the tub on the floor. (See
Fig. 1
)
• Using the adjustable feet on the underside of the tub,
ensure that the tub is level.
• Ensure that there is a gap between the tub base and the floor.
Gap shall not exceed 1/8" [3 mm]. (See
Fig. 2
)
• Using the traced outline for reference, confirm that the
drain/waste outlet in the floor will align with the tub drain outlet.
(Tub drain outlet will be located in the center of the traced
outline. See
Fig. 3
)
Note: The drain/waste outlet must be installed in
accordance with all local building codes.
All drain connections must be made using an
access created beneath the tub.
• The tail piece assembly, consisting of a flanged tail piece, drain
tail piece gasket and slip-joint nut used to connect the the tub
drain to the drain/waste outlet, is included with this product.
• The 1-1/2" diameter tail piece is compatible with drain provided.
(See
Fig. 4
)
• Slide the slip-joint nut over tail piece towards the flanged end as shown.
• Slide the P-trap slip-joint nut and seal over the tail piece as shown.
• Insert the tail piece into the P-trap
.
• The flange of the tail piece should be approximately 5-3/4" [145 mm] or
4-7/8" [124 mm] depending on model, above the finished floor when fully
inserted into the P-trap.
• The tail piece can be cut if necessary.
INSTALLATION INSTRUCTIONS:
REMOVE THE TUB
INSTALLING THE 1-1/2" DIAMETER TAIL PIECE ASSEMBLY
INTO P-TRAP
FIG. 1
1/8" MAX
(3 mm)
FIG. 2
FINISHED FLOOR
FIG. 3
DRAIN
FLOOR CUTOUT
TRACED
OUTLINE
DRAIN TAIL PIECE GASKET
SLIP-JOINT NUT
TAIL PIECE
P-TRAP
FIG. 4
(INCLUDED)
THREADED PORTION
OF DRAIN BODY
TAIL PIECE
ASSEMBLY
For MODEL#
D12536-004
5-3/4" [145 mm]
For MODEL#
D12536-014
4-7/8" [124 mm]
FINISHED
FLOOR
SLIP-JOINT NUT
P-TRAP
& SEAL
(PROVIDED BY
INSTALLER)
(PROVIDED BY
INSTALLER)
