15
Assembly - Balun
□
1.
Install the Balun mounting plate with clamps and coax clamp to the rear of the 20 meter driven
element as shown. Do not tighten the Balun Clamps until step 5.
□
2.
Verify the COMTEK Balun leads are facing the 20 meter driven element.
□
3.
Attach one of the balun strap to one of the screws on the 20 meter driven element using the
feedline strap and hardware as shown above. Adjust the balun position so there is no strain on
the feedline strap.
□
4.
Attach the second Balun feedline strap as above.
□
5.
Tighten the Balun mounting clamps in place.
NOTE:
The following three steps may completed after the antenna is installed on the tower.
□
6.
Install the coax clamp assembly behind the COMTEK Balun as shown.
□
7.
Connect the feed line to the COMTEK Balun
□
8.
Slide the piece of tubing over the feed line and insert this assembly into the small clamp.
□
9.
Seal the Balun connection with the supplied coax seal.
Summary of Contents for SkyHawk 3X10
Page 17: ...17 Element Position...
