- 12 -
11. Using the customer supplied 4" OD antenna bottom element section. Loosen the previously
installed U-Bolts (Step 9). Insert the your 4” OD bottom element section into the antenna base
section through the three U-Bolts with the feed point at the bottom facing front as shown
below.
The bottom of your 4" OD element tube should be even with the bottom of the insulated channel
as shown below.
Tighten the U-Bolt hardware evenly so the length of the exposed threads is approximately equal.
Any clamp should be tightened evenly from side-to-side with an equal amount of thread above
each nut.
Summary of Contents for DXE-VA-PIVOT-4
Page 23: ...22 NOTES...
