- 6 -
Repositioning the Tilt Base on the Mounting Pipe
Loosen the two V-Clamps holding the
Tilt Base to the Mounting Pipe.
Lower the Tilt Base so there is 4-1/2" clearance
between the bottom of the Tilt Base and the Top
of the Radial Plate.
Raise the antenna back to the vertical position. Tighten the
Tilt Base bolts for lowering/raising the antenna.
Assembling the UNUN Mounting Bracket
Using the #6 hex head bolts, #6 flat washers and #6 Nyloc nuts, attach the UNUN to the UNUN
Bracket with the SO-239 connector facing downward. Tighten the Nyloc Nuts so they are snug. Do
not over tighten since the mounting tabs on the UNUN are plastic.
Attach the custom Stainless Steel 90 degree Studded Element Clamps to the patented UNUN
Bracket using the Washers, Aluminum Spacers and #10 Nyloc Nuts as shown below. Snug the #10
Nyloc nuts just to the point that you can still rotate the custom studded element clamps. The #10
Nyloc Nuts will be tightened later.
