Page 32
S1Pi
Set Point 1 Power Interrupt. Select
0n
or
0FF
.
0n
Alarm Power Interrupt is
0n
. Output will automatically
reset on power-up if no alarm condition exists.
0FF
Alarm Power Interrupt is
0FF
. Output will be in the
alarm condition on power-up regardless of condition of
process.
S1iH
Set Point 1 Inhibit: Select
0n
or
0FF
.
0n
Alarm Inhibit is On. Alarm action is suspended until the
process value first enters a non-alarm condition.
0FF
Alarm Inhibit is OFF.
S1LP
Set Point Lamp: Select
0 on
or
0oFF
.
0 on
Lamp ON when Output is ON.
0oFF
Lamp OFF when Output is ON.
If your control is not equipped with Set Point 2, then proceed to the
alarm section (next page).
S2t
Set Point 2 type: Select
Ab
or
dE
.
AbS
Absolute
SP2
.
SP2
is independent of
SP1
, and may be
set anywhere between the limits of
SPL
and
SPH
.
dE
Deviation
SP2. SP2
is set as a deviation from
SP1
, and
allows
SP2
to retain its relationship with
SP1
when
SP1
is changed (
SP2
tracks
SP1
).
S2St
Set Point 2 State: Select
dir
or
rE
.
dir
Direct Action. As the input increases the output will
increase. Most commonly used in cooling processes.
rE
Reverse Action. As the input increases the output will
decrease. Most commonly used in heating processes.
If
0ut2
is set for ##
tP
, #
PUL
, or
ProP
, then
S20L
and
S20H
appear. If
0ut2
is set for
0n 00F
, then skip
S20L
and
S20H
.
S20L
Set Point Output Low Limit: Select 0 to 100% but not greater than
S20H
. This item limits the lowest output value. This is useful for
adding a bias to the process when needed. Factory set to 0 for
output codes 1,2, 3, 4, and 8. Factory set to 20 for output code 5
(20% output equals 4 mA output).
S20H
Set Point 2 Output High Limit: Select 0 to 100% but not less than
S20L
for output codes 1, 2, 3, 4, or 8. Select 0 to 102% but not
less than S20L for output code 5. This item allows setting the
maximum output limit. This is useful with processes that are over
powered. Adjustment to 102% allows setting current output to
If
0u
item
poin
that
Note
2 Re
rese
belo
S2r
S2P
S2
S2L
ALA
Whe
the v
tion
949-1265:Layout 1 1/25/11 10:23 AM Page 32
1.800.868.7495
QualityInstruments-Direct
.ca
