LED Indicator Definition
LED
Color Indication
Network Blue Flash blue while Network activity.
Power
Red
Steady red for booting up process
Blue Steady blue for booting up completion
Purple Flash purple during firmware upgrading; when reset button
pressed for at least 5 sec. to factory default
Unlit When you press reset button; or Power off
Reset: When the device is empowered, press the Reset Button to reboot the
device, or hold the Reset Button for 10 seconds to the settings back to factory
default.
Reset process: Press reset button until indicator Unlit
steady red (booting up
process)
steady blue (booting up completion)
Reset to default process: Press until indicator steady blue
steady red (booting
up process)
steady blue (booting up completion)
Power Mode
PoE Mode
Power Requirement
PoE (IEEE802.3af) with Class 3
Power Consumption 4.19W
Adaptor
Mode
Power Requirement
12V/1A Adaptor
Power Consumption 4.24W
Install the hardware and connect all cables
A.
Hardware Installation
a.
Loosen the tamper-proof screws using supplied L-type Hex Key Wrench
b.
Remove the dome cover. Be careful do not scratch the cover glass.
c.
If you want to route cable from the side of camera instead of routing hole,
please see below figure.
1.
Attached the alignment sticker to the wall/ceiling. Drill three holes into the
wall, which two for screws and one for cable (if you want to route cables
through routing hole).
2.
Align the two holes on the base of plastic plate with the two plastic anchors
on the wall or ceiling, insert the supplied screws to the corresponding hole
and fix them.
3.
Secure the camera to the plastic plate with screws(M2.5x6 * 2pcs)
4.
Adjust the angle of camera to aim the shooting area.
4