Installation
13
Tip:
A camera setup adapter, such as Veracity Pinpoint, can be used to connect a laptop
directly to the camera when using PoE.
Camera Mounting Instructions
Read the instructions provided in this chapter thoroughly before installing the CB-5222 camera. The
following points are additional considerations:
There must be a fuse or circuit breaker at the starting point of the electrical wiring
infrastructure.
For indoor installations, such as industrial applications, the CB-5222 camera must be
protected from hostile external elements (e.g., corrosive environment, metallic dust,
extreme temperatures, soot, moisture, over spray, etc.)
Do not place the CB-5222 camera on or near radiators and heat sources.
All electrical work must be performed in accordance with local regulatory requirements.
Caution:
To avoid damage from overheating or unit failure, assure that there is sufficient
temperature regulation to support the unit’s requirements (cooling/heating). Operating
temperature should be kept in the range specified for the product with no more than
90% relative humidity, non-condensing.
Attention:
Afin d'éviter tout dommage dû à une surchauffe ou toute panne de l'unité, assurez-vous
que la régulation de température est suffisante pour répondre aux exigences de l'unité
(refroidissement/chauffage). La température de fonctionnement doit être maintenue
dans la plage de température spécifiée pour le produit sans condensation d'humidité
supérieur à 90%.
To mount the camera
Screw the camera’s mounting base into the ceiling/wall/flat surface.
Set the camera in a fixed position for the Field of View required.
Connect the cables and wiring to the camera. See Figure 5: CB-5222 Camera
Input/Output Connections.
