DVS Pronto3, Hardware Manual

Page: 31 / 72

2-13
Overview
2
1
3
4
5
I
A
2.2.4 Main Connector Panel
The main connector panel provides the standard in- and outputs of the
Pronto3 to give you the full functionality of the system. It holds, for ex-
ample, the connectors for remote control and the digital video in- and
outputs (serial digital interface).
Figure 2-12: Main connector panel on rear
The additional connectors of the serial digital interface (i.e. the
main SDI A ports) can be found in the slot panel area (see sec-
tion “Slot Panel Connectors” on page 2-15).
Pin-outs of most connectors can be found in section “Signal In-
and Outputs” on page A-9.
For the availability of connectors not present at the system’s
rear (blind panels) please contact DVS.
Item Description
RMT In DB-9 connector (female), serial RS-422 inter-
face for an input of slave control signals
RMT Out DB-9 connector (female), serial RS-422 inter-
face for an output of master control signals
not connected These connectors provide no functionality
Dig. Audio Ch. 1-8 DB-25 connector (female) for a balanced audio
signal in- and output of the digital audio
channels 1 to 8 (AES/EBU); XLR connectors are
available via a breakout cable
Dig. Audio Ch. 1-8 Ch. 9-16
GPI RMT In RMT Out AUX 1
LTC In LTC Out
PUSH
SDI In B SDI Out B CVBS Out
WCLK Out SD SDI Out SD SDI In
SATA
not connected