-8-
3 Status LED:
Lights blue on both the TX and RX to indicate the
presence of an active DisplayPort signal connected to the TX unit.
4 Hot Plug Detect (HPD) LED:
Lights blue on the RX unit when a
DisplayPort Monitor is connected to the RX. Will also light blue on the TX
unit at the same time, if a working fiber link is present.
5 Ethernet LED:
Lights blue to indicate Ethernet traffic.
Transmitter Unit (DVI-7380-TX) – Rear View
Receiver Unit (DVI-7380-RX) – Rear View
1 Optical Output Connector (TX):
Connect a Single-Mode or Multi-Mode
Fiber Optic Cable. The DVI-7380-TX uses LC optical connectors.
1 Optical Input Connector (RX):
Connect a Single-Mode or Multi-Mode
Fiber Optic Cable. The DVI-7380-RX uses LC optical connectors.
2 DP Input (TX):
Connect to a DisplayPort source.
2 DP Output (RX):
Connect to a DisplayPort display.
3 Infrared (IR) IN:
Connect the included IR receiver to accept IR signals
for transmission over the fiber link. See Section 4.2 for further details.
3 Infrared (IR) OUT:
Connect the included IR transmitter to accept IR
signals over the fiber link and output them to a peripheral device. See
Section 4.2 for further details.
4 RS-232:
3-pin female Phoenix Connector for serial data pass-through.
5 LAN Ethernet Ports:
Extends 10/100Base-T network connectivity over
the fiber link.
6 +12 VDC Power Input:
Locking female connector for AC Power Adapter.
1
2
6
3
5
2
1
6
3
5
