DVIGear DVI-7312 Quick Start Manual Download Page 4

Page: 4 / 4

DVIGear

1059 Triad Court, Suite 8,
Marietta, GA 30062
Toll Free: 888.463.9927
Tel: 770.421.6699
Fax: 770.234.4207
[email protected]
www.dvigear.com

Instructions for Learning the EDID from a Display

1.)

Apply power to the display.

2.)

Connect the DVI-7312 Transmitter unit to the display’s DVI input port.

3.)

Connect the External AC Power Adapter to the Transmitter unit.

4.)

Press the Learn EDID button (page 2 - #5) by manually inserting a stylus into the side of the

Transmitter unit. If the EDID is properly read, the BLUE Indicator LED (page 2 - #2a) should
illuminate once.

5.)

Remove the External AC Power Adapter from the Transmitter unit.

6.)

Disconnect the Transmitter unit from the display and connect it to the DVI signal source.

7.)

Follow the Installation Instructions (3-6) listed on page 3.

Insert a stylus to press the Learn EDID Button

Learn EDID Button

DVI-7312-QSG-01 / August.2013

Summary of Contents for DVI-7312

Page 1: ...glass fibers and an optical receiver module that converts the light pulses back to a DVI signal for display on a monitor or projector A programmable memory chip in the transmitter unit captures and st...

Page 2: ...2 DVI 7312 TX Rear View 1 2a 5 4 2b 3 DVI 7312 TX Front View 3 4 2a 5 2b 1...

Page 3: ...device A picture should appear on the display within a few seconds Power Sources The Receiver Unit must draw power from the supplied External AC Power Adapter It does not draw power from the monitor...

Page 4: ...pter to the Transmitter unit 4 Press the Learn EDID button page 2 5 by manually inserting a stylus into the side of the Transmitter unit If the EDID is properly read the BLUE Indicator LED page 2 2a s...