Network Setup:
1)
Unpack your OnRamp/IP, power it up and connect two network cables from the
OnRamp/IP to a switch.
2)
Connect your PC to the same switch (alternatively, you could use a crossover
cable between your computer and the OnRamp/IP).
3)
The IP address for the OnRamp is on a label on the back of your system, just
above the WAN port. Use this IP address to enter the web interface.
4)
At the password prompt, enter
admin
for username and
admin
for password.
These are the default security credentials.
5)
Go to the “Network Setup” tab (the second from right tab) and configure all the
network adapters on the OnRamp/IP.
NOTE:
Some of the web interface sections will only show up if you have purchased
that option.