MAINTENANCE
Proper maintenance is very important to ensure your treadmill is always in top working condition.
Improper maintenance could cause damage or shorten the life of your treadmill and exceed the
LIMITED WARRANTY coverage.
1. Important: Never use abrasives or solvents to clean the treadmill. To prevent damage to the
computer, keep liquids away and keep it out of direct sunlight.
2. Inspect and tighten all parts of the treadmill regularly. Replace any worn parts immediately
CLEANING:
Routine cleaning of your treadmill will extend the product’s life.
1.
Warning:
To prevent electrical shock, be sure the power to the treadmill is OFF and the power cord is
unplugged from the wall electrical outlet before attempting any cleaning or maintenance.
2.
Important:
Never use abrasives or solvents to clean the treadmill. To prevent damage to the computer,
keep liquids away and keep it out of direct sunlight.
1.
After each workout:
Wipe off the console and other treadmill surfaces with a clean, water dampened soft
cloth to remove excess perspiration
4.
Weekly:
Use of a treadmill mat is recommended for ease of cleaning. Dirt from your shoes contacts the
belt and eventually makes it to underneath the treadmill.
Vacuum the underneath treadmill
once a week.
BELT ADJUSTMENT:
Belt adjustment and tension performs two functions: adjustment for tension and centering. The running
belt has been adjusted properly at the factory. However transportation, uneven flooring or other
unpredicted reasons could cause the belt to shift off center resulting in the belt rubbing with the plastic
side rail or end caps and possibly causing damage. To adjust the belt back to it proper position please
follows the directions below:
1.
Walking belt has shifted to the left:
First unplug the power cord from the surge protector. Using the hex key provided, turn the left rear
roller adjustment bolt 1/4 turn in the clockwise direction. Plug the power cord back into the surge
protector and run the treadmill at 2.5 mph. You should see the belt start to correct itself, moving
back towards the center. Repeat the above procedure until the walking belt is centered. It may be
necessary to set walking belt tension once you have completed this procedure if the belt feels like
it is slipping while walking. Refer below to the “Walking belt slipping” instructions.
2.
Walking belt has shifted to the right:
First unplug the power cord from the surge protector. Using the hex key provided, turn the right
rear roller adjustment bolt 1/4 turn in the clockwise direction. Plug the power cord back into the
surge protector and run the treadmill at 2.5 mph. You should see the belt start to correct itself,
moving back towards the center. Repeat the above procedure until the walking belt is centered. It
may be necessary to set walking belt tension once you have completed this procedure if the belt
feels like it is slipping while walking. Refer below to the “Walking belt slipping” instructions.
3.
Walking belt is slipping:
First unplug the power cord from the surge protector. Using the hex key provided, turn both the left
and right rear roller adjustment bolts the same distance, usually a 1/4 turn in the clockwise
direction. Plug the power cord back into the surge protector and run the treadmill at 2.5 mph. You
should now walk on the belt to determine if the belt is still slipping. Repeat the above procedure
until the walking belt is not slipping. The tension should be just tight enough not to slip.
WARNING! Do not over tighten rollers! This will cause premature roller bearing failure!
25
EN