setup
1. Unpack and Check Box Contents:
Remove entire contents of box. Check each item against the Parts List. (pg. 4)
Notify Dustless Technologies
®
immediately if any parts are damaged or missing.
2. Install Rod and Float:
Place upside down on a flat surface.
3. Wrap Filter around Filter Cage.
4. Place the Filter Cage, Filter and Wing Nut over the Float.
How to use
Operation:
Place vacuum on drum. Push hose onto the
intake port. Plug in vacuum.
The on/off switch is located on the shroud
below the cap.
Do not operate vacuum without float or
filter in place
When the drum is full of liquid, the
automatic shut-off mechanism will shut
off air flow. When this happens, the motor
sound will become
noticeably higher in pitch. Turn cleaner off
and empty or replace drum to continue
use.
Storage:
Disconnect from electrical outlet. Remove
from drum. Store in a dry location indoors.
Wrap the cord carefully around the
vacuum to avoid
accidental damage.
Tighten with wrench
Thick foam down
Thick foam down
Tighten Wing Nut
