Installation Instruction
DUST COLLECTION SYSTEM FOR RIGHT ANGLE GRINDERS
1. Loosen band clamp.
2. Slip around grinder’s collar.
3. Center DustBuddie on the arbor
and tighten band clamp.
4. Install grinding wheel.
(Use the washers provided to adjust
wheel slightly below the brushes. You
may also adjust the 3 screws if needed)
5. Insert Adaptor Hose in shroud port, then secure
the other end of the Adaptor Hose to the electrical
cord by wrapping a releasable tie around both.
Go to www.dustlesstechnologies.com for more information
800.568.3949
dustlesstechnologies.com
Includes:
1 Clear polycarbonate
shroud w/brackets
and clamp
1 18” Flexible Hose
3 Washers
1 Removable clip
1 Releasable tie
Installation Steps:
This product was inspected and pack-
aged carefully before being shipped
from the factory. If you should happen
to need assistance during assembly or
operation, call 1-800-568-3949 for our
customer service department.
Always make sure grinder is UNPLUGGED when removing or attaching front nose clip. Before use, refer to your tool manual for warnings and instructions.
WARNING
Instructions for Crack Chasing/Tuckpointing Application
Cut
Line 1
Cut
Line 2
D1835 5” Dust Buddie Complete set
D1850 7” Dust Buddie Complete set
A. 1 - D5115 S32 CLAMP 5 “ (D5125 S44 CLAMP for 7”)
B. 1 - D5150 RELEASABLE TIE
C. 1 - D1835.1 5" MAIN BODY W BRUSH (D1850.1 for 7”)
D. 1 - D1835.2 5" REMOVABLE CLIP W BRUSH (D1850.2 for 7”)
E. 1 - D1835.3 5" BRUSH SET (D1850.3 for 7”)
F. 3 - D1835.4 5" BOLT (D1850.4 for 7”)
G. 3 - D1835.5 5" NUT (D1850.5 for 7”)
H. 3 - D1835.6 5" ALUMINUM BRACKET (D1850.6 for 7”)
I.
3 - D1835.8 5" METAL WASHER (D1850.8 for 7”)
J. 3 - D1835.9 5" SPRING (SAME for 7”)
K. 1 - D1853 BUDDIE WASHER SET - (SAME for 7”)
L. 1 - D5155 18" DM BLK HOSE
Manual 082010
1. Tighten all 3 screws until bracket touches shroud.
2. Remove brushes. In the brush groove there is a plastic thin
rib that will have to be cut out in order to snap
coverplate in place.
3. Remove shroud clip, trim with band saw or cutting blade
as follows:
a. Trim on “Cut line 1” if cutting blade is directly in front of grinder
b. Trim on “Cut line 2”, if cutting blade is at a
45° angle
4. Install cutting wheel using washers provided to center the wheel
5. Snap cover plate in place (not included with grinding kit)
A.
B.
C.
D.
E.
F.
G.
H.
I.
J.
L.
K.
HEPAKit16008:Layout 1 8/20/10 8:49 AM Page 1
