SETUP
SUPPORT
1. Remove screws from the bottom front end
of your Husqvarna gas saw (circled). Screws
are located between the 2 front feet.
2. Mount the front bracket for the Husqvarna
gas saw over the two holes where you just
removed the screws. Align the holes with
the holes in the brackets and install the two
new included screws with the nut between
the handle and the saw body, the washer
is to be on the bottom of the handle next
to the head of the screw. Tighten down the
screw till secure then tighten down the nut
to the body of the saw till secure.
3. Install the rear mounting bracket by remov-
ing all four screws from the bottom back
side of the saw (circled). Install the rear
mounting bracket and replace the screws
and tighten till secure. Magnet plate should
be located at the back of the saw.
4. Install the DustBull to your Husqvarna gas
saw by lining up the holes in the bell of
the DustBull with the holes on the front
bracket. Insert the 6” bolt and then install
the included Nyloc nut on the end and
tighten down till secure.
5. Attach 2” vac hose to the back of the
DustBull.
www.dustlesstools.com
OM019_0116
Installation instructions for the Husqvarna Gas Saw
Rear Bracket
Front Bracket
