Dustbane 19319, Operation Manual

Page: 14 / 44

14 Operations Manual Hurricane 400 XTT / Hurricane 400 XTT – Traction
MAINTENANCE INSTRUCTIONS
! DANGER: Never perform any maintenance operations without first disconnecting the batteries. Maintenance on the electrical circuit and
all other operations not explicitly described in this manual must be performed by specialized personnel only, in compliance with current
safety legislation and
as described in the maintenance manual.
! DANGER: Before lifting/rotating the tank to access the compartment, its contents must first be emptied, then insert the safety bracket in
position to prevent the tank from accidentally closing again, see chapter “SAFETY INFORMATION”.
Maintenance - General rules
Performing regular maintenance according to the Manufacturer’s instructions improves performance and extends the working life
of the machine.
When cleaning the machine, observe the following precautions:
• Avoid using pressure washers. Water could penetrate the electrical compartment or motors leading to damage or short
circuits.
• Do not use steam to avoid the heat warping plastic parts.
• Do not use solvents or hydrocarbon based products. These can damage the cowling and rubber components.
Suction motor air filter and float switch: cleaning
Fig./Abb./
图
7
Fig./Abb./
图
9 Fig./Abb./
图
8
Fig./Abb./
图
10 Fig./Abb./
图
11
1
3
2
4
5
• Unscrew and remove the tank cap (ref. 1) from the dirty water drum (ref. 4);
• Make sure the dirty water drum (fig. 10, ref. 4) is empty;
• Clean the float switch (ref. 5) at the back of the dirty water drum, taking care not to direct the water jet directly against
the float switch;
• Remove the suction motor air filter (ref. 2) from the float switch support (ref. 3) inside the dirty water drum at the top;
• Clean the filter with running water or the detergent solution used on the machine;
• Dry the filter thoroughly before replacing it in the support. Make sure the filter is correctly located
in its housing;
• Screw the cap back on the dirty water drum.
Basket filter: cleaning
• Remove the basket filter from the water fill hole at the front of the machine;
• Clean the filter with running water or the detergent solution used on the machine;
• Replace the filter back in its housing, making sure it is correctly positioned.