5
Assembly
1. Align arrows in separator canister Top (B) and
Separator Canister Bottom (C) and snap pieces
together to create the full canister.
Fig. 1.
2. Insert the five casters (H) into the corresponding
sockets on the bottom of the canister.
Fig. 2.
3. Position the lower Chip Separator Ports (G) underneath
the lid with the indents on the Lower Port aligned with
the indents on the lid.
Fig. 3. Be sure the Lower Ports
are pointing in opposite directions.
Fig. 4. Then
Thread the Upper Chip Separator Port (F) to the
Lower Port (G), sandwiching the lid (A) in between.
4. Secure the Separator Lid (A) to canister by aligning
the lid tab with any one of the 3 tab cutouts in the
Canister’s top rim. Rotate clockwise to secure,
reverse to remove.
Fig. 5.
5. Thread both hose fittings (E) to either end of the
FlexForm
™
hose (D).
Note: Threading is reversed on these fittings.
6. Insert one end of the FlexForm
™
hose (E) into
Chip Separator Port (G) and the other end into
your shop vacuum.
Fig. 6.
Note: Either end can be used as the input or
output ports.
Fig. 5
Fig. 4 - Underside of lid shown
A
G
Fig. 6
Fig. 3
Fig. 2
Fig. 1
F
E
D
A
G
F
Triangle
indent
C
H
B
C
Align
arrows
Tab cut-out
Lid tab
