TILT-LAMP INSTALLATION
(Fig.6 )
To maximize the efficiency and life of the UV-C
lamp, clean each lamp prior to installation.
Use isopropyl alcohol and cotton cloth to wipe
dust and fingerprints from the lamp.
Gently insert the lamp into the lamp hole.
While holding the lower slide bracket under
the retaining lip of the lamp, push the upper
slide bracket over the retaining lip of the lamp
and tighten the two knurled nuts until the lamp
is securely fastened.
Fig. 6
Hold lower slide bracket in place under lamp retaining lip
while pushing upper slide bracket over lamp retaining lip. Secure
with two knurled nuts.
Mercury Hazard. Do Not Break.
Each UV-C lamp contains a small amount of
Mercury. May cause redness or irritation. Use
proper disposal techniques in case of breakage.
WARNING
UV-C Light Hazard.
UV-C light can cause temporary or permanent
loss of vision, and sunburn. Take precautions
to protect eyes and skin from direct exposure.
WARNING
BIO-FIGHTER® 4XTREME INSTALLATION & OPERATION MANUAL
5
IMPORTANT:
The device must be installed in compliance
with all national and local electrical and
mechanical codes. Failure to do so will void
Dust Free® warranty.
CONDUIT INSTALLATION
(Fig.4 )
Remove the two cover retaining screws and
swing open the cover to access ballast and
wiring. Install an appropriate weatherproof
conduit on the side of the enclosure.
Drill
points are marked on two sides of the enclo-
sure where it is safe for conduit installation.
Connect the electrical service, through the
conduit, to the ballast wires. Connect the black
and white wires to power and the green wire to
ground. Refer to Fig. 5 for wiring diagram.
Conduit installa-
tion points indi-
cated by dimples
on outside of
enclosure.
Fig. 4
Install weatherproof electrical conduits at either of the loca-
tions marked by dimples on the outside of the enclosure.
Fig. 5
Wiring diagram.
Electrical shock hazard.
Can cause injury or death. Before perform-
ing any service or maintenance disconnect
electrical service to the unit.
WARNING
White Wire
Black Wire
Green Wire
To 120V - 240V
Electrical Service
Ballast
To Ground
Lower slide bracket
Lamp retaining lip
Lower slide bracket
Lamp retaining lip
Important:
O-ring
must be between slide
brackets to prevent
damage to ceramic
lamp base.
Upper slide bracket
Upper slide bracket
