8. Fit flange plate (6) on the flange plate (3).
9. Fit flange plate (8) on the flange plate (6).
10. Lubricate screws (7) M6 x 16.
11. Screw-on flange plates (6) and (8) into the
flange plate (3) using four screws (7).
4.3
Lubricating Hoses
Personnel:
Mechanic
+ additional qualification explosion protection
Protective equipment:
Eye protection
Protective workwear
Protective gloves
Anti-Static Safety Boots
Materials:
W32120005 - Petroleum jelly 40 g
Due to the robot movement, hoses rub
against each other and on the inside of the
convoluted hose. These contact areas are
denominated as torsion sections. A constant
film of lubrication is required along the tor-
sion sections.
1. Place hoses next to each other on a clean and
flat surface.
Fig. 5: Torsion Section (Example)
2. Spread petroleum jelly evenly on 2 m along the
torsion section (1).
ð
Also apply petroleum jelly between
hoses.
Fig. 6: Lubricating Hoses (Example)
4.4
Putting Hoses in Order
Personnel:
Mechanic
+ additional qualification explosion protection
Protective equipment:
Eye protection
Protective workwear
Protective gloves
Anti-Static Safety Boots
NOTICE!
Distorted Hoses and Lines
If distorted and twisted hoses and cables are
installed, the hoses and cables can be damaged
due to robot movement. That could result in
property damage and production disruptions.
– Put Hoses and cables in order before
assembly.
Hoses are lubricated.
1. Place hoses next to each other on a clean and
flat surface.
2. Bundle and order hoses.
Hoses must not be contorted or twisted with
each other.
Assembly
03/2019
Atomizer Connection EcoGun - MRS00004EN
10/24
