Durr Dental 6024100001, Installation And Operating Instructions Manual

Page: 17 / 36

❯
Adjust the time and tap Save . Tap to go
back.
Automatic adjustment
In order to use automatic time setting,
DHCP must be activated (see "9.7 Con-
figuring the network").
❯
Tap Time Zone .
❯
Adjust the time zone and tap
Save
.
9.4 Adjusting the temperature
❯
Tap Sealing Parameters > Temperature .
❯
Adjust the temperature.
❯
Tap Save .
Recommended sealing temperatures:
– 180 °C is recommended for Hygofol transpar-
ent sterilisation packaging.
– For sterilisation packaging from other manu-
facturers, the recommended sealing tempera-
ture should be checked with the relevant man-
ufacturer.
After adjusting the temperature, perform a
test sealing process.
9.5 Set the speed for the belt
transport
The speed of the belt transport can be adjusted
between
Slow , Medium and Fast .
❯
Tap Sealing Parameters > Speed .
❯
Select the required speed, tap e.g. Medium .
❯
Tap to go back.
❯
Perform a sealing test, see "14.2 Daily function
assessment").
After changing the speed it may be nec-
essary to adjust the sealing temperature
(see "9.4 Adjusting the temperature").
9.6 Set standby time
❯
Tap System Settings > Standby .
❯
Tap + or - and adjust the time.
It is set to 30 minutes by default.
❯
Tap Save .
9.7 Configuring the network
After the network settings have been
changed it is necessary to restart the
device. This saves the changed settings.
Requirements:
ü Access level Administrator or Service Techni-
cian selected.
If DHCP is activated then the settings are
applied automatically.
Deactivate DHCP if you wish to adjust the
settings manually.
❯
Tap System Settings > Network .
❯
Deactivate
DHCP
.
❯
Tap IP Address , enter the data and tap Save .
❯
Tap
Net Mask
, enter the data and tap
Save
.
❯
Tap Gateway , enter the data and tap Save .
Syslog settings
If the unit is monitored using third-party docu-
mentation software for documentation of the
sealing processes, Syslog settings will still need
to be adjusted for it.
Syslog IP address: IP of the computer on which
the documentation software is running.
Syslog port: The port via which the units are
communicating (default setting: 514).
It is important that no other program is allowed to
access the same port on the computer on which
the documentation software is installed, as other-
wise that port will be blocked and the documen-
tation software will not be able to receive any
data.
❯
Tap System Settings > Network > Syslog IP
Address , enter the data and tap Save .
❯
Tap Syslog Port , enter the data and tap Save .
Syslog Heartbeat is activated at the fac-
tory, which allows the network stability to
be improved.
Assembly
6024100132L02 1906V003 15
EN