Duronic PS581, Manual

Page: 17 / 53

17
Creative
Consumer
Products
Be careful not to place your fingers near the feed opening or else serious harm
could occur.
2. Make sure that all of the excess paper has been removed from the feed opening.
3. You are now ready to resume normal shredding.
In case of a major paper jam:
1. Turn off or unplug the power cord from the AC outlet and wait at least 40 minutes
for the thernal overload protection to reset.
2. Plug in the AC power cord and place the switch back into the AUTO position.
If paper was left inside the feed opening prior to the overload, place the switch
in REV and grasp the excess paper from the top and pull it out. Be careful not to
place your fingers near the feed opening or serious harm could occur.
3. Place the switch back into the AUTO position. You are now ready to resume
normal shredding.
SAFETY INFORMATION
BEFORE USE
• Dispose of all packaging carefully and responsibly.
• This appliance is designed for indoor use only. Do not use outdoors.
• Do not use this shredder for industrial and commercial use, or any other purpose.
• The shredder MUST be positioned on a firm level base before and during use.
• Ensure the power cable is not caught under the appliance.
• Ensure the correct power supply is used (230V AC).
• Keep power cord away from hot surfaces.
• Do not place the shredder near a heat source or in direct sunlight.
• Do not operate under or near curtains or other combustible materials.
• Do not immerse the machine in water or any other liquid to protect against
electric shock.
• Keep out of reach of children.
• Do not spray any flammable synthetic oil, petroleum-based or aerosol products
onto this shredder as it may cause a fire.
• Do not allow the shredder to be exposed to rain or any other moisture.
Important - Please read these instructions fully before installation