Page 17 from 37
The
STATE LED
flashes for 3 seconds to wait for your final selection. After 3
seconds, it saves the selection and operates at the
power level selected
.
Power level 4
Read and reset error
The stove is equipped with a series of sensors
and control mechanisms to ensure the safe
operation of the unit.
In case of an error of any of these control
mehanisms, an error will be recognised by the
stove controller. In case of an error, the STATE
LED turns red and starts flashing.
The
FAULT CODE
can be read by counting the number of flashes.
Check the error list for the error code corresponding to the number of flashes.
After the fault has been recognised and the source problem resolved and fixed,
the alarm on the controller can be reset by pressing the button once.
The
STATE LED
turns green for 2 seconds to confirm the reset.
DHS Toolbox
The DHS Toolbox can be used to read or change parameters and system
configuration from a technician and authorised personnel. The Toolbox can
connect to the revolute via Wi-Fi or direct connection. Changes are not allowed
in the parameters of this menu, as this may cause irreparable damage to the
heating device.
