Duroflame Batavia T3, Technical Manual

Page: 14 / 43

Page 14 of 43
3.3.2 Switching on the pellet stove
Switch on the stove using the feed switch. The feed switch is the switch the feeder
cable is connected to.
Possible defect: 5.1 No image
3.3.3 Ignition

Check that there are sufficient pellets in the tank.

Check that the combustion pot is clean, placed as far back as possible and that
the glow plug is in front of the hole in the combustion pot.

Check that the door is securely closed.
Start the stove by pressing and holding the ON/OFF button until you hear a
beep.
The pellet stove indicates: ‘IGNITION ON’. The pellet stove will start and complete the
following steps:
Cleaning/preheating.
During this phase, the glow plug starts to glow and the combustion pot is cleaned. Possible
malfunctions are:
Malfunction: ERROR 6
Malfunction: ERROR 9
Loading pellets
During this phase, pellets are added until a fire starts in the combustion pot.
The blower will slow down. Possible malfunctions are:
Possible defect: 5.2 No pellet supply
Ignition and stabilisation
After ignition, the flue gas temperature will rise and the stove will recognise this as a fire. The
stove will now enter the stabilisation mode for a few minutes, and the stove will supply fewer
pellets to allow the fire to slowly start. A possible malfunction is:
Malfunction: ERROR 1