5
Bolt-Down the safe
1) Select a suitable and convenient location for your safe.
2) Open your safe and pull drawer to eject fully.
3) Locate the Black Lever on each side of the slide as shown in the picture below.
Pull the lever up on the LEFT and push down on the RIGHT.
4) Pull drawer out. Locate the pre-drilled holes on the base and rear of the safe.
Secure the safe into position with the Bolt-down Screws provided.
5) Push the slides on both sides of the safe inwards. Align the slides with the drawer
and push inwards.
WARNING
TAKE EXTRA CARE when removing the drawer from the safe. The weight on
the front side of the drawer is much more heavier than the rear.
Tips & Precautions
1) Low voltage - the LED Display will flash
lo-bat
when the battery power in the safe
is running low. Please replace with 4 “AA” alkaline batteries.
2) The Factory Personal Code and Factory Master Code will not be able to open the
safe once they are changed. Please keep your programmed codes available.
3) Do not pull the Override Key out in the UNLOCK position.
4) Do not mix batteries. Always change batteries in a set of the same brand.
5) also functions as a Backspace. Press to delete the last entered digit.
6) Do not use any chemical, abrasives, bleach, detergents, solvents or metal scouring
pads on any part of the safe.
Back of Front Panel:
Personal Code
Reset Button
Battery
Compartment
Summary of Contents for 133
Page 1: ...Art 133 ...
