Winder
66
Service manual H867 Version 00.0 - 08/2013
15.2 Setting the winder
Correct setting
The winder wheel runs smoothly and without axial play.
The winding process will stop automatically when the required filling quan-
tity of the bobbin is reached.
Cover
4.4.2 Removing and fitting the arm cover
Figure 52: Removing the winder and setting the winder filling quantity
Setting steps
Removing the winder
1. Loosen the winder screws (1).
2. Remove the winder.
Setting the winder filling quantity
The position of the arms on the winder flap screw (2) determines the filling
quantity:
•
Arms parallel:
Automatic winding stop at 0.5 mm under the edge of the winder
•
Arms closer together:
Automatic stop with larger filling quantity
•
Arms further apart from each other:
Automatic stop with smaller filling quantity
Risk of injury
Switch off the sewing machine before setting the winder.
WARNING
2
3
4
1
(1) - Winder screws
(2) - Winder flap screw
(3) - Winder flap
(4) - Arms
Summary of Contents for M-TYPE H867
Page 1: ...H867 Service manual...
Page 91: ......
