2. Setting up
IMPORTANT !
The special sewing machine may only be set up by trained
specialist personnel.
Packing must be removed prior to setting-up.
–
Remove safety bands and wood from upper part, table and frame.
–
Remove safety bands and block from motor.
2.1 Erecting the upper part
If the special sewing machine was not delivered fully assembled:
–
Screw hinges 2 and 3 to base plate.
Attach upper-part support 1.
–
Fit upper part.
–
Fit and tension V-belt (see section 2.3).
–
Fit belt guard and oil bath.
–
Align surge container 9.
The surge container must be turned so that it is vertical when the upper part of the
machine is vertical.
–
Place oil-recirculation felt 7 in the depression of the oil bath.
The hose 8 must not make contact with moving parts.
2.2 Transport
For internal transport the sewing machine must be lifted and moved by a suitable
vehicle (e.g. a fork-lift).
2.3 V-belt tension
After the machine has been moved the pre-set V-belt tension must be checked.
The tension in the V-belt 6 must be such that it can be depressed by about 10 mm by
applying finger pressure in the middle.
–
Loosen nuts 4 and 5.
–
Swivel drive until V-belt tension is correct.
–
Retighten nuts 4 and 5.
GB
5