DURKOPP ADLER beisler 2112-5, Service Instructions Manual

Page: 26 / 104

Setting up the machine
24 Service Instructions 2112-5 - 00.0 - 02/2020
7.2 Adjusting the downforce pressure of the assistance
transport
Fig. 13: Adjusting the downforce pressure of the assistance transport
Checking the downforce pressure
To check the downforce pressure of the assistance transport:
1. Position sewing material at the loading position.
2. Lower the stamp (2).
3. Try to pull the sewing material out of the stamp at several locations
along the transport section.
 The downforce pressure needs to be the same at all locations.
Adjusting the downforce pressure
To adjust the downforce pressure:
1. Set the pressure reducer (3) to 1 bar (0.1 mpa).
2. Check parallel alignment of the stamps (2) to the sliding plate.
If the alignment of the stamps must be adjusted:
3. Loosen the screws (1).
4. Adjust the height position of the assistance transport (4).
5. Tighten the screws (1).
(1) - Screws
(2) - Stamp
(3) - Pressure reducer
(4) - Assistance transport
③
④
①
①
②