7.6
Material guide adjustment
For a correct guiding of the sewn material against the cutting knife
a tipping guide can be used.
The guide can be lowered in the bottom position independent of the
cutting knife holder by pushing down of the control lever (1). Another
possibility is to switch the guide on and off simultaneously with the
switching on the edge trimmer main lever (2), which is ensured by
pushing down of the pin (3) in the upper (switched off ) position of both
levers.
–
With the lowered control lever (1), slightly loosen the bolt (4) and
with an Allen key (5) turn the bolt (6) to achieve the required lateral
position towards the cutting knife.
–
At the same time it is necessary to set the position of the guide (7)
in the sewing direction by its turning in the lever (1).
–
Set the suitable height of the guide over the throat plate by turning
of the setting bolt (8).
–
After adjusting the guide, tighten the fixing bolt (4).
For better guiding of the sewn material it is possible to use a retaining
part (9) attached to the guide (7), the height of which can be set up
after the fixing bolt (10) loosening.
Another possibility is using the sewn material tipping guide (can be
ordered as an optional equipment) fixed on the bed plate.
42
1
4
6
10
9
2
3
8
5
7
Summary of Contents for 887 Series
Page 1: ...887 Service Instructions...
