DURKOPP ADLER 869-M Premium, Service Instructions Manual

Page: 108 / 180

Programming
106 Service Instructions 869-M PREMIUM - 00.0 - 07/2018
19.6.11 Setting the Pedal (
Pedal
) parameter
Various settings can be made for the pedal. The possibilities are explained
in more detail in the table.
19.6.12 Setting the Needle cooling (
NeedleCooling
) parameter
Various settings can be made for the needle cooling. The possibilities are
explained in more detail in the table.
Menu item Setting options
Type DA Analog/Digital
Choice between an analog and digital pedal.
Inverted
Inversion of the signals given by the pedal (possibly necessary
for digital setpoint devices).
(Value range: On/Off)
N StepsPedal
Number of speed steps processed by the pedal.
(Value range 00 – 64)
Curve
Speed curve of the pedal.
t Posit. -1
Debouncing of position -1
(Value range 000 – 255 [ms])
t Posit. -2
Debouncing of position -2
(Value range 000 – 255 [ms])
t Posit. 0
Debouncing of position 0
(Value range 000 – 255 [ms])
Menu item Setting options
Off
Needle cooling is deactivated.
On
Needle cooling is activated.
t After Sew
Lag time, after which the needle cooling is deactivated.
(Value range 00.0 – 10.0 [ms])
AtSpeed t After Sew
Lag time, after which the needle cooling is deactivated.
(Value range 00.0 – 10.0 [ms])
CoolSpeed
Speed at which the needle cooling is activated.
(Value range 0000 – 6000 [rpm])
Edge cutter
Needle cooling is activated when the edge cutter is also activated.
t After Sew
Lag time, after which the needle cooling is deactivated.
(Value range 00.0 – 10.0 [ms])