With the delivery of the machine only the test software (allowing the
loading of sewing software) is installed in the control unit. The test
software offers no further functions. If the test software gets damaged
during the loading process, it is no longer possible to load a software
using a dongle.
In such a case use a PC with a loader cable.
Hint:
The sewing unit is delivered with a machine software installed on it.
CAUTION !
Turn off the main switch before connecting the dongle.
10.2 Loading the program
–
Turn the machine off at the main switch.
–
Insert the dongle
2
into the socket X110 (TEST-Interface)
1
of the
control unit (see pictures).
–
Switch on the main switch. The Software will be loaded. The
loading process takes less than 60 seconds.
–
During the loading process do not remove the dongle and do not
switch off the machine (otherwise you will damage the software) !
–
During this time, the version of the control panel will be displayed ,
e.g.
“BF1 C A 03"
(blue screen).
–
When the loading process is finished, the program version will be
displayed e.g. “
745 A01
”.
–
The new operating system must be confirmed via the “
OK
” key.
Then the operating system will be started.
–
Remove the dongle
2
from the socket X110..
–
Confirm the software version by pressing the “OK” key.
–
The machine is ready for operation.
Hint!
Remove the dongle before re-starting the machine, otherwise it will
load the sewing program again.
After a replacement (first installation) of the DAC III control, the error
message Error 9900 or Error 9901 or Error 9902 will be displayed after
loading the operating system.
An initialization must first be carried out (see part 4 chapter 6).
.
25
2
1
2
