1. Never short circuit the unit by connecting the red (+) and black (-) clamps, this will permanently damage the unit
and will not be covered under warranty.
2. Never destroy the jump starter as the material inside may be hazardous.
3. Keep children away from the product.
4. Store in a dry place, do not expose to damp conditions or near corrosive materials.
5. If the jump starter expands stop use immediately and disconnect.
6. Please only operate the unit within the operating temperatures below.
7. Please do not turn over the vehicle for more than 3 seconds or damage to the jump pack, battery or leads could occur.
8. Please do not start the vehicle continuously, between starting twice you should allow an interval of at least
30seconds to 1 minute.
9. When the battery power of the unit is less than 10% please do not use the jump starter as it will damage the unit,
charge immediately.
10. Before first use charge for 3 hours or more.
11. Only use to jump start vehicle where 50% or more battery life is available from vehicle battery.
12. Please do not jump vehicle with engine larger than stated. In this case 4.0L DIESEL & 7.0L PETROL.
13. Never attempt to open the unit or repair. Always seek the professional advice from manufacturer.
14.
MUST NOT BE USED TO JUMP START ANY VEHICLE WITH A LITHIUM ION BATTERY - RISK OF DAMAGE OR INJURY!
Capacity .............................................................
Battery Cell .......................................................
Output Voltage ...................................................
Start Current .....................................................
Peak Current ....................................................
USB Output x 2 .................................................
Charge Mode ....................................................
Cycle Lifetime ...................................................
Dimensions .......................................................
Operation Temperature .....................................
15,000mAh / 55.5Wh
Li-Polymer
12V/16V/19V (Max Current Draw 2.5A/3.5A/3.5A)
300Amps
600Amps
5V/2.1A
15V/1A
1000 Times
l 189 x w 84 x h 47mm
-20
℃
- +60
℃
Parameters
＜
10.5V±0.5
＞
65±5
℃
Item
Stand-by mode
Force to jumpstart mode
Short-circuit protection
Reverse polarity protection
Reverse charging protection
Low voltage protection
High temperature protection
Serial NO.
1
2
3
4
5
6
7
Description
Red and Green LED flashing alternatively, it will
turn into “Solid Green” after you connected
product with the vehicle battery correctly
Hold the “side button” to activate the Force to
jumpstart mode, the LED would turn into “solid
Green”
Red LED solid on and the buzzer beeps rapidly.
(Note: Do you attempt to short-circuit the
clamps when the LED is “Solid Green”)
Red LED flashing (Note: There is high current
charging back to the booster pack which is
harmful)
Red LED flashes 4 times per second, and the
buzzer beeps 1 times per second
Red LED solid on and the buzzer beeps 1 time
per second (Note: To prevent the product from
being over-discharged, which is harmful to the
lithium battery)
Red LED solid on and the buzzer beeps rapidly.
(Note: The clamps were reverse connected)
SMART JUMP LEADS LED INDICATION
0-649-27-LEAFL
0-649-27-LEAFL
Mini Jump Pack for 12VDC Vehicles
Part 0-649-27
Mini Jump Pack for 12VDC Vehicles
Part 0-649-27