DURAVIT Happy D.2 Plus 760453, Mounting Instructions

Page: 9 / 92

en
* or the height of
the highest shower
head / water outlet
that is permanently
installed, depending
on which is higher
DANGER
Risk of fatal electric shock
> Disconnect the power supply while working on the
electrical components.
> The device must be earthed. Earthed appliances must
be permanently connected to fixed wiring.
> Connect the device only to the designated electrical
cable.
> NEVER touch the power supply cord with wet hands.
Pre-installation
> Lay a permanent power supply line which must be on a
separate circuit.
• The device itself does not have electrical leakage
protection function. The device should be supplied
through a residual current device (RCD) having a
rated residual operating current not exceeding
30 mA.
• Means for disconnection must be incorporated in the
fixed wiring in accordance with the wiring rules and
have a contact separation in all poles that provides
full disconnection under overvoltage category III
conditions outside the prescribed safety areas (0 – 2).
• Leave 3 000 mm of the supply line exposed.
> Lay an equipotential bonding cable:
• Leave 3 000 mm of cable exposed.
> Check rating label for rated power and choose cable
cross section accordingly (2.5 mm – 4 mm).
> Confirm that the grounding wire is 10 mm (⅜ ”) longer
than the L and N wire.
> Install circuit breaker.
76xxx xx x xx00: 50 Hz, 220 - 240 V AC
76xxx xx x xx06: 60 Hz, 220 - 240 V AC
I
N
= 16 A
I
ΔN
≤ 30 mA
Power supply
Circuit breaker
RCCB
Safety areas in accordance with DIN VDE 0100-701
600
600
2250*
0
1
2
I
L
N
PE
1
2
Mounting instructions
11
Connecting the whirltub
NOTE
Avoiding any malfunctions!
> Do not fasten the cables together with cable ties.
> Do not install the supply line parallel to the control
cables.
I
1. Connect the supply line to the mains supply socket.
2. Connect the potential equalisation cable to the
whirltub.
57081_WH_M_Acrylic_FST/19.05.3
9