17
Rear Suspension
1. Install a 6mm ball stud (125) into the rear of the suspension arm (8) as shown in the diagram. Note: This is for the
shock to attach to.
2. Install the rear suspension arm (8) onto the rear bulkhead (6) and secure it in place by installing the rear inner hinge pin
(88) then install a 2.5mm e-clip (U) onto the end of the hinge pin (88).
3. Install a 4.3mm ball stud (124) into the lower camber rod position on the rear hub (9).
4. Install the rear hub (9) onto the outer end of the rear suspension arm (8). Secure the rear hub in place with an outer
rear hinge pin (90). Secure the hinge pin in place using a 2.5mm e-clip (U). Note: The stock position for the hub to
mount onto the arm is the lower hole in the hub.
5. Install two 5x10mm bearings (38) into the rear hub (9). Note: Make sure the bearings are properly seated in the hub
to prevent binding.
6. Install the rear axle shaft (44) into the 5x10mm bearings installed into the rear hub (9).
7. Secure the rear axle shaft (44) by installing the 2x10 axle pin (40) through the hole in the shaft.
8. Install the wheel hex adapter (39) onto the rear axle shaft (44) and key it onto the 2x10mm axle pin (40).
9. Install the dogbone between the differential joint and the rear axle shaft. Then install the turnbuckle assembly (81 & 82)
onto the ball studs.
