❏
5. Drill two 1/4" (6mm) holes in front of body using the
molded-in dimples as guides. Install the front brush guard
as shown with two 2.6 x 6mm self-tapping screws and the
collars included.
❏
6. Drill one 1/8" (3mm) hole in each side of the body
using the molded-in dimple as a guide, and one 5/64"
(2mm) hole 7/16" (11mm) below and 7/16" back from first
hole (use the pegs on the mirror as a guide). Install the
mirrors as shown with the collars provided.
❏
7. Mount the body on the body posts and secure the body
to the truck with (4) body clips.
Congratulations,
you have completed assembly! Before
running your new truck, please take the time to carefully
read the instructions and watch the video before running
and breaking-in the engine. Make sure you follow the safety
precautions and most of all
...
HAVE FUN!
The High-Speed Needle
The “high-speed” needle is sticking up from the side of the
carb. It is located in the brass housing, just above the fuel
inlet. It controls the fuel to air mixture of the carb. The
needle is pre-set for break-in from the factory at 2-3/4 turns
out from the fully closed position of the carb. Once the
engine is broken-in, the high-speed needle would typically
run from 2 to 2-1/2 turns out from closed, depending on the
weather, humidity and altitude above sea level. To richen
turn the needle counterclockwise, to lean turn the needle
clockwise.
CARBURETOR SETTINGS
14
