7
❏
1. Install the “AA” batteries in the transmitter and the
receiver holders.
❏
2. Install and extend the transmitter antenna.
❏
3. Connect the steering servo, throttle servo and
receiver battery to the receiver.
❏
4. Uncoil and extend the receiver antenna.
❏
5. Adjust the servo trims of the transmitter to the
neutral position.
❏
6. Switch on the transmitter.
❏
7. Switch on the receiver.
❏
8. Operate the steering and throttle control. Make
sure the servo arms move in proportion to the
movement of the steering wheel and throttle trigger.
❏
9. Switch off the receiver, then the transmitter.
❏
1. Remove the Maximum MT Pro stadium truck
from the box.
Place a check mark in the check boxes after each step
is completed.
❏
1. From bags PA001 and PA003, remove (8) 3 x 8mm
self-tapping screws, and the (2) L-shaped servo mounts.
❏
2. Attach the servo mounts to the steering servo as
shown with (4) 3 x 8mm self-tapping screws. Note that the
servo spline will mount towards the rear of the truck.
STEERING SERVO ASSEMBLY
PREPARING THE RADIO SYSTEM
ASSEMBLY OF THE MAXIMUM MT PRO PRE-BUILT VERSION (DTXC0091)
Servo Arm
Steering
Servo
Throttle
Servo
Receiver
Battery
Holder
4-AA Batteries
1
Antenna
4
Receiver
3
Receiver
Switch
7
Transmitter
5
6
8-AA Batteries
1
Antenna
2
8
Before installing the radio
system in the pre-built
DuraTrax Maximum MT Pro
read the manufacturer’s
instruction manual and
follow the instructions
shown below.
