8.3
Stripping paint
Set a higher air temperature.
Switch the tool on.
Direct the hot air onto the paint to be removed.
When the paint softens, scrape the paint away using a hand scraper.
Do not strip metal window frames, as the heat may be conducted onto the glass
and crack it. When stripping other window frames, use the glass protection
nozzle.
Do not keep the tool directed at one spot too long to prevent igniting the surface.
Avoid collecting paint on the scraper accessory, as it may ignite. If necessary,
carefully remove paint debris from the scraper accessory using a knife.
8.4
Stationary use
This tool can also be used in stationary mode.
Place the tool onto the workbench.
Secure the cable to prevent pulling the tool off the workbench.
Carefully switch the tool on.
Make sure that the nozzle always points away from you and any bystanders.
Make sure not to drop anything into the nozzle.
8.5
Cooling down
The nozzle and becomes very hot during use. Let it cool down before attempting to move or store
the tool.
To reduce the cooling time, switch the tool on at the lowest air temperature setting and let it run
for a couple of minutes.
Switch the tool off and let it cool down for at least 30 minutes before storing.
9
MAINTENANCE AND CLEANING
Attention! Before performing any work on the equipment, pull the power plug.
9.1
Maintenance
Your Power Tool has been designed to operate over a long period of time with a minimum of
maintenance. Continuous satisfactory operation depends upon proper tool care and regular
cleaning.
9.2
Cleaning
Keep the ventilation slots of the machine clean to prevent overheating of the engine.
Regularly clean the machine housing with a soft cloth, preferably after each use.
Keep the ventilation slots free from dust and dirt.
If the dirt does not come off use a soft cloth moistened (not dripping wet) with soapy water.