www.durapac.com
Page 5
Always use a flat, hard surface as a cylinder support plate. To reduce cylinder offset
loading, optional tilt saddles are available. Always use grease underneath swivel
saddles (see Figure 2).
Figure 2 – Tilt Saddle.
6.0
Maintenance
Important: Use only good quality hydraulic fluid. Never use brake fluid, transmission fluid, turbine
oil, motor oil, alcohol, glycerine etc. Use of other than good quality hydraulic oil will void warranty
and damage the cylinder and application.
Maintenance is required when wear or leakage is noticed. Periodically inspect all components to
detect any problem required service and maintenance. Important equipment must only be serviced
by a qualified hydraulic technician. For repair service, contact your local Durapac service centre.
1.
Check for loose connections and leaks
2.
Replace damaged parts immediately
3.
Do not exceed oil temperature above 60
o
C
4.
Keep all hydraulic components clean
5.
Use dust caps when cylinder is disconnected from the hose. Keep entire cylinder clean to
prolong cylinder life
6.
Wipe clean, thoroughly and store cylinders upright (to prevent seal distortion) in clean, dry
environment. Avoid temperature extremes
7.
Change hydraulic oil in your system as recommended in the pump instruction sheet
