4
Parts Needed:
(2) Column short
(COSP)
(13) Column long
(COLP)
(4) Column support
(CS)
(1) Wall panel front left
(WP1A)
(1) Wall panel front right
(WP2A)
(4) Wall panel corner
(WP3A)
(6) Wall panel side
(WP4A)
(1) Sliding channel right
(SRBP)
(1) Sliding channel left
(SLBP)
(1) Sliding channel joint
(SJP)
(1) Sliding channel cover
(SCBP)
(2) Top angle side left & right
(ASBP)
(1) Top angle back left
(ABLBP)
(1) Top angle back right
(ABRBP)
(2) Center band front
(CB1P)
B. Walls & Columns
All panels are clearly marked
and care should be taken to
use the correct one.
Note
(2) Center band side front
(CB2P)
(2) Center band side back
(CB3P)
(6) Center band middle
(CB4P)
(1) Door column profile left
(DCLP)
(1) Door column profile right
(DCRP)
(4) Corner column fitting
(CCFP)
(7) Center band fitting
(CBFP)
(2) Front column fitting
(FCFP)
(15) Column fitting
(CFP)
(2) Door Column bottom fitting
(DCBFP)
(4) Top slider
(TS)
(148) Plastic washer
(PW)
(6) Vantilation Blocking Cover
Front/Back
(VBCF)
(248) Sheet metal screw
(S1)
(20) Sheet metal screw
(S7)
IMPORTANT: USE HAND GLOVES TO PREVENT INJURY.
9
. Secure the base (BBFP) to the foundation with
(S1) screws.
BBFP
S1
BBFP
10
. Place the entrance taper channel (ECBP) on
top of the (BBFP). Secure with (S1) screws to the
foundation. See fig. 1 & 2.
S1
Fig.1
Fig.2
ECBP
BBFP
BBFP
BBFP
ECBP
After completing the assembly
of the base bar fill the concrete
or sand upto the foundation
top suraface
Note