- 5 -
Step 3:
A:
Fix the Swing bar (6L) on the long axle of the Handlebar post (2) with Hex bolt (24),
Spring washer (52), Flat washer (25), Waved washer
(54)
and Long axle (27) as shown.
Please do not tighten them this time.
B:
Attach the connecting joint together with Pedal Support (5L) to the Crank (22) using
Pedal support bolt (38L), Waveform washer (62), Spring washer (41) and Nylon nut
(42L) as shown. Please do not
tighten them this time.
C:
Connect Swing bar (6L) with Pedal
support (5L) using Hex bolt (30),
Flat washer (31) and Nylon nut
(32). Tighten the Hex bolt (24) (30)
and Nylon nut (42L). Finally Cover
the Nut caps (23) (57) (43)(36).
D:
Fix the Pedal support (5R) and
Swing bar (6R) to Crank (22) and
Handlebar post (2) in the same
way.
E:
Fix the Pedal (10L/R) to the Pedal
support (5L/R) with Hex bolt (33),
Flat washer (34) and Nylon nut
(35).
Step 4:
A:
Put the Pulse sensor wire (50) through
the handlebar post (2) and then out of
the hole of the computer bracket. Fix
the armrest (8) on the handlebar post
(2) with Hex screw (51), Spring
washer (52) and then cover the
Handlebar chuck cover (53) to the
related position.
B:
Attach the Handlebar (7L/R) to the
Swing bar (6L/R) using Carriage bolt
(45), Arc washer (44) and Acorn nut
(58).
Step 5:
