2
of 5
August 19, 2016
BATTERY BACK UP & CHARGER
Auto-revert to Battery or Power Supply ................................................................. provided by dual Shottky diode in OR configuration
Maximum Output Current in Battery Mode ..................................................................................... 40 Amps (limited by Shottky diode)
Maximum Charge Voltage ...................................................................................................................................................... 55.6 VDC
LOW VOLTAGE DISCONNECT with RELAY
Maximum Interrupt Current / continuous current ............................................................................................................... 40 Amps DC
Disconnect Voltage ................................................................................................................................................................... 42 VDC
Reconnect Voltage .................................................................................................................................................................... 50 VDC
Disconnect Delay ..................................................................................................... 2 minutes @ less than preset disconnect voltage
INSTALLER NOTES
NOTE: DO NOT
block any of the cooling vents on the sides and top and always allow adequate ventilation by not installing the unit
inside tightly closed spaces. Physical mounting position is not critical but the cooling vents must not be blocked.
NOTE:
The outputs are
NOT
referenced to the chassis.
The Modular System can be used either positive or negative ground.
FRONT PANEL LAYOUT
Power Supply Module ON/OFF
Manual Battery Disconnect Switch
Load Power
