Duracell Powerpack Pro 1000, User Manual

Page: 10 / 14

Problem: The engine being jumpstarted will not start.
Possible Cause Solution
Duracell ® Powerpack Pro battery is not fully
charged.
Recharge the Duracell ®
Powerpack Pro battery.
The engine condition is poor. Have the engine serviced.
The engine start capacity exceeds the
Duracell
® hPowerpack Pro jump-start
capability.
Use a higher power Duracell
®
Powerpack Pro.
Problem: The jump-start clamps measure zero volts.
Jump-start power switch is OFF. Turn the jump-start power switch ON.
Duracell ® Powerpack Pro battery needs to be
recharged.
Recharge the battery.
P roblem: The compressor runs, but won’t infl ate.
The valve connector may not be securely
placed on the valve stem. Make sure the valve connector is
securely placed on the valve stem
before closing the thumb latch.
The item being infl ated may have a leak. Make sure the item being infl ated
doesn’t have a leak.Check the
compressor hose for any breaks or
leaks.
Problem: The compressor runs slowly.
The compressor may have overheated from
excessive use. Turn off the compressor and let it cool
down.
Battery voltage is too low. Check the condition of the internal
battery. The battery may need to be
recharged or replaced.
13. User reference: Tire inflation
The information in the table below is for reference only. For precise
pressure specifi cations, refer to the information supplied with the item to
be infl ated.
Type of tire Typical pressure
specifi cations (PSI)
Automotive tires
520-13 26
A-78-14 26
E78-14 30
H-78-14 24
HR-78-15 28
Bicycle tires
27 x 1 ¼ 85
20 x 1 ½ 40
Other Infl atables
Football 13
Basketball 9
Volleyball 5
Lawn tractor tire 22
15. Warranty and return information
Quality guarantee
Battery-Biz guarantees the Duracell ® Powerpack Pro to be free of defects due
to faulty materials or workmanship. This Duracell
®
Powerpack Pro carries a
2-year limited warranty from the date of purchase.
If found to be defective, this Duracell ® Powerpack Pro will be replaced without
charge when returned to Battery-Biz. This guarantee does not apply to damage
from misuse or abuse beyond normal usage. This guarantee gives you specifi c
legal rights, and you may also have other rights which vary from state to state.
Should any device be damaged by the Duracell
® Powerpack Pro due to defects
in the product arising from faulty materials or workmanship, Battery-Biz will
repair or replace (at our option) the Duracell
® Powerpack Pro, provided both
device and product usage instructions have been followed.
Send device with the Duracell ® Powerpack Pro to:
Battery-Biz Inc.
1380 Flynn Road, Camarillo, CA 93012
Attention: Duracell Product Returns
If you would like additional information on Duracell products call
1-800-842-2127.
Contacting customer support
If you experience any problems or have any questions regarding your
Duracell
® Powerpack Pro, free technical support is available. Prior to calling,
please review the technical support tips below.Call from a phone where you
have access to your device.
Be prepared to provide the following information:
•
Name, address and telephone number
• Name of the DURACELL
®
product
• Make and model of your device
• Symptoms of the problem(s) and what led to them
Technical Support is available by telephone:
•
U.S. and Canada (800) 842- 2127
• Outside of the US/Canada: (805) 437-7765
Written inquires should be directed to:
Battery-Biz Inc.
DURACELL Product Inquiry
1380 Flynn Road, Camarillo, CA 93012, USA
Two year limited warranty
The Duracell
®
Powerpack Pro carries a limited warranty against defects in
material and workmanship under normal use and service for two years from
the original date of purchase. The battery inside the product carries a limited
one year warranty, from the date of purchase, against defects in material
and workmanship under normal use and service. Battery-Biz, at its option,
shall repair or replace the defective unit covered by this warranty. Please
retain the dated sales receipt as evidence of the date of purchase as it will be
required for any warranty service. In order to keep the warranty in effect, the
product must have been handled and used as described in the instructions
accompanying this warranty. This warranty does not cover any damage due
to accident, misuse, abuse or negligence. If maintained properly the Duracell
Powerpack Pro will provide years of dependable service.
12. Troubleshooting
Below are some common problems that can occur with the Powerpack.If
you cannnot solve your problem, contact your dealer or Duracell Customer
Service at (800) 842-2127.
Problem: AC appliance will not operate.
Possible Cause Solution
AC appliance rated more than 300 W
(Powerpack Pro 1000) or 600 W (Powerpack
Pro 1300): the safety overload has tripped. Use an AC appliance with a power rating
less than 300 W.
AC appliance is rated less than 300 W
(Powerpack Pro 1000) or 600 W (Powerpack
Pro 1300): high starting surge has tripped
the safety overload. AC appliance may exceed the Duracell
®
Powerpack Pro’s surge capability. Use an
AC appliance with a starting surge within
the Duracell
® Powerpack surge rating.
Battery has discharged to 10.5 V. Turn OFF the AC Power ON/OFF switch
and recharge the Duracell
® Powerpack.
Duracell ® Powerpack Pro has overheated
due to poor ventilation or excessively warm
environmental conditions.
Turn the AC Power ON/OFF switch OFF
and allow the Duracell
® Powerpack Pro
to cool for 15 minutes or more. Clear
blocked openings or remove objects
covering the unit, then restart the
Duracell
® Powerpack and move it to a
cooler environment.
Problem: Overload shutdown.
Possible Cause Solution
Appliance power
requirements exceed
the capability of the
Duracell
® Powerpack Pro.
Unplug the appliance and confi rm that
the appliance’s power requirement is
300 W (Powerpack Pro 1000) / 600 W
(Powerpack Pro 1300) or less before
attempting to restart the appliance.
Problem: Measured AC output voltage is too low
.
Possible Cause Solution
Using an average-reading AC voltmeter to
read output voltage. The modifi ed sine wave output of the
Duracell
® Powerpack requires a true
RMS reading meter, such as the Fluke
87 series, for accurate measurement.
Duracell
®
Powerpack Pro battery is almost
fully discharged.
Press Battery Level button to verify
battery status and recharge the
Duracell
® Powerpack Pro as necessary.
Battery Level LEDs are only accurate
when the unit has been disconnected
from all appliances and all charging
sources for 15 minutes.
Problem: Battery Status LED is red and has not changed
to green after 24 hours of charging.
Possible Cause Solution
The voltage at the AC wall outlet is less than
120VAC.
Use AC wall outlet that supplies 120VAC.
Continue to charge the unit for another
12 hours; the unit will be ready to use
even if the Battery Status light remains
red.
14. Specifications
Important notes
All specifi cations are subject to change without notice.
12V DC section
Internal battery type Sealed/non-spillable, AGM (Ab-
sorbed Glass Mat) lead-acid
Internal battery voltage (nominal) 12V DC
Internal battery capacity (minimum) DR300PWR ........................15Ah
DR600PWR ........................18Ah
DC power socket (maximum continu-
ous load) 20 A with automatic reset
AC power section
Output power
• Continuous output power DR300PWR ............ 240W
DR600PWR ............ 480W
• Output power (5 minutes) DR300PWR ............ 300W
DR600PWR ............ 600W
• Peak AC output surge capacity DR300PWR ............ 480W
DR600PWR ............ 750W
Output voltage 115V AC (RMS)
Output frequency 60Hz
Output wave form Modifi ed sine wave
No load current draw <0.5 A DC
Input voltage range 10V to 15V DC
Low battery alarm 10.5V DC
Low battery shutdown 10.0V DC
High battery voltage shutdown 16V DC
Over temperature shutdown <194° F (90° C)
Overload shutdown Yes, automatic reset
AC output short circuit protection Yes, automatic reset
Fuse (Internal) DR300PWR...40A x 1 (MAX),
DR600PWR...35A x 2 (MAX)
Operating temperature range 32º–104 ºF (0º–40 ºC)
Storage temperature range 68º-122º F (-20º C - -50ºC)
Internal battery charging controller system
AC input voltage range 100-240V AC
AC input frequency 50/60Hz
Output voltage 15V DC
Rated voltage in fl oating charge 13.2Vdc@30mA
Empty load power < 0.5W
Safety standards ETL
Effi ciency standards BC, CEC V
Air compressor
Pressure 160 PSI (lb/in)
Accessories
AC cord 52.4 in. (133cm)
Compressor nozzles Red air nozzle, blue air nozzle,
infl ator needle
Physical specifi cations
Length 15.2 in. / 38.5 cm
Width 9.3 in. / 23.7 cm
Height 10.7 in. / 27.2 cm
Weight DR300PWR ............ 16.8 lbs. / 7.6 kg
DR300PWR ............ 20.9 lbs. / 9.5 kg