Version 20190806 Page
4
Fig. 8
Fig. 9
ON mode:
Slide the switch to the ON position, the system will remain ON all the time no matter the power cord is connected
or not. Only remote transmitter is disabled.
REMOTE mode:
Slide the switch to the REMOTE position (middle), the system will ONLY operate with receiving commands
from the remote transmitter.
OFF mode:
Slide the switch to the OFF position, the system will remain OFF all the time. Remote transmitter and Receiver
box are both disabled.
★
NOTE: The OFF mode is strongly recommended if house is unattended for a long time. For safety, placing the slide
switch in the OFF position also functions as a safety “LOCK-OUT” by both turning the system off and disable the remote
receiver.
WARNING & REMINDER
This system MUST be installed exactly as complied with these instructions. Read all instructions before installation,
and follow them during installation carefully.
Any modifications of Durablow remote control system, or parts, or components are PROHIBITED. They will void the
warranty, and may cause a fire hazard result in human casualties and property damages.
Do NOT connect any gas valve or electronic module directly to power source.
Read gas appliance manufacturer’s instructions and wiring schematics completely for proper placement of all
wires. All electronic modules are to be wired to manufacturer’s specifications.
All wiring diagrams in these instructions are for illustration purpose ONLY. Follow instructions from manufacturers of
gas valve and electronic module for correct wiring & installation procedures. Improper installation of electric components
can cause damage to electronic module, gas valve and remote receiver.
PRE - INSTALLATION
Decide where to install the receiver box before proceeding. Less
metallic shielding / blocking, better signal strength.
The remote receiver box can be placed on the fireplace, under the fireplace, behind the control panel or louvers....etc.
Keep away from high-heat of exceeding 130°F. Additional protection is required for no exposure to the heat.
Make sure the receiver box’s slide switch is in the OFF position before installation.
