Dura-Trel, Inc.
~ P.O. Box 122, Sheboygan Falls, WI 53085 ~ Toll Free 877-258-6020
TOOLS NEEDED
Hammer or Mallet
Drill with #2 Phillips drill bit or
Phillips Screwdriver
ARBOR SIDE PANELS
(Refer to Drawing 1) (Make 2)
On a clean flat surface lay two of 61” bent tubes down using the Drawing as your guide. Slide the
horizontal cross rails over bent tubes in the order shown on Drawing 1.
Note:
Bent tubes are marked
with a black mark on inside of tube to indicate top end.
(Refer to Drawing 2)
Lay one of the trellis legs so the routed holes are facing up and the pilot holes for screws are facing you.
Insert the horizontal cross rails from assembly above into the trellis leg, add the bottom rail in the last
routed hole of leg and slide the bent tubes into the outer holes of the bottom rail. Press another leg over
the opposite ends of the cross rails. Lay the panel flat, (make sure cross rails are completely in both legs)
and fasten with screws. Snap the screw caps over the screw heads.
Stand panel up and slide the straight tube through the center holes.
ARBOR TOP ASSEMBLY
(Refer to Drawing 3)
Lay one of the bent arbor top rails on flat surface with routed holes for tubes facing up. Insert a tube in
each of the holes, press the other bent arbor top over the opposite ends of the tubes and fasten the bent
tops to the center 3 tubes with screws. Snap screw caps on screw heads. Set the flared ends of the arbor
top assembly onto the side panels. The screw caps of the panels should face the outside of the completed
arbor. Arbor is now ready for installation.
INSTALLATION
In desired location set the arbor in place and mark where ground anchors will need to be inserted. Using a
block of wood to protect the flared edges of ground anchors; pound the anchors into place. (If ground is
extremely hard, loosen or soak soil before inserting ground anchors). Set arbor into ground anchors. In
windy areas it is recommended that you use the four extra screws to fasten the arbor to the ground
anchors. Drill a small pilot hole in the ground anchors and fasten.
If you encounter missing or defective parts, please call manufacturer direct at the toll free # below.
#11107M
3’
R
OSEBUD
A
RBOR
ASSEMBLY INSTRUCTIONS
