INSTALLATION OF THE FAUCET
1
New Faucet Preperation
First, shut off the water supply and remove
the old faucet by disconnecting it from the
supply lines under the sink, and
unscrewing the faucet from the countertop
by removing mounting nuts. Next, clean
the sink’s top surface in preparation for the
new faucet.
2
Fastening Deck Plate
(Optional)
The base plate can be used without a
sealant, but if desired apply plumbers
putty or other suitable sealant to the
bottom edges of the base plate (optional).
Once applied, align base plate and press
into place to firmly attach to the sink.
Lastly, remove excess plumbers putty and
place desk plate onto base plate.
3
Secure Faucet
Remove the lock-nut provided. Place the
faucet on sink top and feed hoses down
through the center hole in the sink. Next,
from below the sink, secure the faucet by
re-attaching the lock-nut (A) and screwing
it down with the 2 set screws until tight
(B/C).
4
Connect Supplies
Securely attach marked supply lines with
corresponding hot (A) and cold (B) hoses
from the faucet. Tighten all connections
with wrench to ensure that no leaking
occurs. With all connections plumbers
tape can be utilized to help reduce the
risk of leaking.
5
Install Metal Weight
Attach the weight to the hose at a length
suitable to you (the further from the end
you place the weight the longer your
reach will be when pulling the hose out for
use). You may move the weight to adjust
the pull-down length of the hose.
Carefully tighten the weight.
6
Flush Lines
Once installation of the hoses is complete,
remove the spray head. Turn the water
supply on and allow both hot and cold
water to run for at least 30 to 60 seconds
each. While water is running, check for
leaks around and under the sink. Once
done replace aerator and start enjoying
your new Dura Faucet.
MAINTENANCE AND CLEANING
Cleaning Tips: The finish on your product
is designed to retain its beautiful sheen
for years. To maintain the original look of
the finish, a little care and caution should
be used. We recommend the use of mild
soap and water to clean the product.
THE USE OF ABRASIVE CLEANERS MAY
SCRATCH THE FINISH OR CAUSE
OTHER DAMAGE.
RECOMMENDED TOOLS AND
MATERIALS
¨
Adjustable Wrench
¨
Plumbers Tape (Thread Seal
Tape)
¨
Phillips Screw Driver
BEFORE YOU BEGIN
There are a variety of things to do before
installing any new plumbing system into
your home or residence. Before you begin
work make sure you:
¨
Shut off the main water supply
¨
Cover your drain to prevent
loss of parts
¨
Observed any local plumbing
codes
¨
Inspect fixture for damage -
Replace as necessary
Dura Faucet reserves the right to make any
revisions in the design of products without
notice.