Duplo DBM-70, Instruction Manual

Page: 4 / 17

DBM70 Instruction ver 1.doc Page 3 3/12/01
3 . INITIAL SETTING UP
1. Remove the bolts holding the machine to the pallet.
2. Castors are already fitted to the machine, lift from the pallet on to an even surface.
3. Remove packing from stapling section and from under fold stop beneath the conveyor.
4. Lower output conveyor, allowing the slotted ends on the support bars (part no. 6.06) to locate
on the protruding bolts provided. These bolts are located at the base of the machine.
5. Fit the conveyor wheels.
Figure 2 - Conveyor setup.
6. Insert the conveyor end stop (part no. 6.11) at the far end of the conveyor, making sure it does
not infringe the belt.
7. Position the machine near to a suitable socket outlet and ensure outlet is not covered and is
easily accessible.
8. Adjust paper infeed wheels and back jogger to correct position for paper size selected.
See Section 10 for collator stand assembly and online connection. Check that the power supply is of
the correct voltage for the machine. Once connected, the machine is ready for use.