~ 5 ~
~ 6 ~
TO ADJUST THE CLAMP PRESSURE
1. Press the dual cut buttons (7) simultaneously to lower the
clamp until the clamp press the paper tightly, and read off the
clamp pressure on the clamping pressure gauge (8).
PS: Normal setting: min. 35 kg/cm², max. 50 kg/ cm²
2. Turning the clamp pressure adjustment switch (6):
To increase pressure, turn the adjuster clockwise.
※
To decrease pressure, turn the adjuster anti
※
-clockwise.
Re-press the cut buttons simultaneously until the clamp
presses the paper tightly to read the new revised pressure.
PS: Do not adjust the pressure too low (normal setting: 30 kg/
cm² or more); otherwise, the guillotine will beep.
TO CHANGE THE KNIFE
1) Turn the knife change switch (2), set the Mark-VII control in
“MANUAL” mode.
2) Turn the knife depth micro adjustment (3) anti-clockwise to 0,
(minimum position).
3) Press both cut buttons until the knife down to the bottom
position.
(Don’t release any one of the cut buttons during the
operation, otherwise you will have to re-start the procedure
from the first step.)
4) Using the tools provided, remove all knife holding bolts. Insert
the two knife change handles into the knife through the two
open ended slotted holes in the knife carrier tightly.
5) Turn off the knife change switch, the knife carrier will return to
the top position.
6) Holding the knife change handles and loose it slightly, remove
the knife from the knife carrier.
7) Change the cutting stick to a fresh un-used side.
8) Using the knife change handles to insert the new knife into the
knife carrier and push the knife to the top of the slots and
tighten the handle against the carrier.
9) Turn the knife change switch on.
10) Press both cut buttons until the knife down to the bottom
position.
