computer radio control system
computer radio control system
●
RC Power Switch (RCPS 5, RCPS 10)
The power supply is connected via a two-wire cable. The positive
pole is switched, the negative pole is common.
For switching on constant currents lower than 5A, use the
RC
Power Switch 5
.
For switching on constant currents lower than 10A be sure to use
the
RC Power Switch 10
.
2.1
Update
The RC Switch allows updating the firmware via PC. Updating is
done using the Jeti USB adapter.
Procedure
:
1.
Find the program to update to the latest firmware on the
manufacturer's website under
"Downloads"
. Save it to your
computer.
2.
C
onnect the USB adapter to your computer. The procedure of
installing the drivers for the USB
adapter is included in the USB
adapter manual.
3.
Run the firmware update on your PC.
4.
Connect the USB adapter to the RC Switch (Ext. output) using a
three-wire cable.
5.
Přehodit pořádek slov: After connecting the device the update
will begin.
The maximum switching current must not be exceeded, see
chapter
„
3. Technical data
”
.
EN
16
