Duotronpro S-600, Operating Instructions Manual

Page: 10 / 28

- 9 -
4. Install
(1) Connect AC Power
This furnace requires AC230V and maximum current is 8A. This furnace should be connected
directly to over 15A breaker in a panel board. (Do not use extension cords and connecting
to other equipment. Insufficient capacity may cause a short circuit and fire.)
(2) List of parts
After open a box, ensure there are all parts. Also, check any visual damage. If you find any
damages or defects, contact seller.
- Furnace housing ..................................................................................................... 1pc
- Instruction .................................................................................................................. 1pc
- Ceramic tray .............................................................................................................. 1pc
- Ceramic lid ................................................................................................................ 1pc
- Substructure for tray ............................................................................................ 1pc
- Zirconia beads (100g) .......................................................................................... 1pc
(3) Installation
Avoid sunlight or moist when installing the product. Also, install on a level
place. Dust could damage on heating elements, thus, install in clean
environment.
Place a furnace at least 30 cm apart from the wall and 1.5 m away from the
ceiling. If too close to wall or ceiling, may cause a fire and damage on
product.
Do not place flammable materials on the top of product. Before use, install
a ventilation system above the product to remove harmful gas during
sintering.