DUOTONE CLICK BAR, User Manual

Page: 14 / 26

16
DUOTONE
CLICK BAR MANUAL
2. The release mechanism is triggered by pushing the release grip down.
3. The safety leash is then completely released from your harness.
Pictures
35
+
36
+
37
page 26
4.4. SLIDING BAR STOPPER
CAUTION: THE SLIDING BAR STOPPER LIMITS THE SCALE OF DEPOWER AND SHOULD BE
ADJUSTED TO THE RESPECTIVE ARM’S LENGTH. PUSH THE STOPPER AS FAR AWAY FROM YOU
AS POSSIBLE. YOU SHOULD BE ABLE TO ONLY JUST REACH THE BAR AFTER LETTING GO OF IT.
THE SLIDING BAR STOPPER IS NOT THE USUAL STYLE OF STOPPER. FOR SAFETY REASONS THE
STOPPER SLIDES UPWARDS UNDER HIGH PRESSURE.
1. Release the Sliding Bar Stopper by pulling down the lower part of the Stopper.
2. Grab the Stopper and, in an opened position, push it up, or down.
3. Lock the Bar Stopper by pushing the lower part upwards again.
4. With the Grub Screw, the friction of the Stopper can be regulated or the position set. Do not turn
the Screw too tight in order to avoid damaging the sleeve.
Pictures
38
+
39
+
40
+
41
page 27
5. SERVICE AND MAINTENANCE
CAUTION: IT IS NECESSARY TO RINSE YOUR CLICK BAR AFTER EACH USE.
5.1. RINSING THE IRON HEART
Rinse the Iron Heart with clean water. Be sure to open it right up and clean the inside. Move the Roto
Head back and forth to remove any obstructions or residues from the ball bearing and interspaces.
Use the Suicide Ring to also pull out the red safety line (about 80cm) and rinse it to remove sand
from the passageway in the Iron Heart and the TPU cover/sleeve.
Picture
42
page 79
5.2. RINSING THE TRIM UNIT
1. Open the Rubber Plugs on the bottom side of the bar.
SERVICE AND MAINTENANCE