Wind shield calibration:
In the event of a fault, the Hall sensor signals can be calibrated again.
Adjustment:
Here, new sensors can be initialized.
Transmission position sensor
Run the engine in a neutral position and idle for 10 seconds.
The gears are taught in the driving mode, in each gear 10 seconds drive.
Exhaust flap
The exhaust flap is integrated in the exhaust system pipe in front of the rear silencer. In case
of malfunction or replacement, an adjustment must be carried out.
RDC – TPMS service / tire pressure sensors:
Status:
Current information from TPMS control unit.
Read:
Here the current programmed ID sensors A and B can be read out.
Delete:
Any unnecessary sensors or defects can be deleted here.
Write:
Neu Sensoren ID A und B lassen sich hier Programmieren.
Here, the ID is written directly into the ECU, this consists of 6 or 7 digits.
Automatically learn:
Initiate activation of the new sensors. For this function you need a TPMS activator. After the
function has been executed, the RDK sensor must be initialized to transfer the data to the
control unit.
-12-
